Items to Check & Initial Completion:
1. ___ Lube fan and motor bearings
2. ___ Inspect drive and load sheaves
3. ___ Lube and adjust dampers and linkages (use
silicone based lubricant)
4. ___ Check filter(s)
5. ___ Check motor operating conditions. Take amp.
reading
6. ___ Check and tighten all electrical connections
7. ___ Check and clean humidifiers, if applicable
8. ___ Check and clean drains and drain pans
9. ___ Inspect, clean and lube the burner and
combustion control equipment
10. ___ Check burner sequence or operation and
combustion air equipment
11. ___ Check all unit panels and secure where required
12. ___ Inspect roof curb flashing
13. ___ Remove debris from roof along w/filter(s) and
belt(s)
MATERIALS REQUIRED:
1. Belts
2. Filters
3. Lubricants
4. Contact cleaner
5. Panel Screws
6. Cordless drill
7. Panel gasket materials
8. Clean-up materials
Comments and Recommendations:
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
_______________________________________________________________________________
Table of Contents | Next