Man Hours 1.5
Special Instructions:
1. Review manufacturer's instructions.
2. Disconnect, lock and tag switch out.
Items to Check & Initial Completion:
1.___ Inspect structural features, framework, support members, anchor bolts, pit,
platform, etc. Examine condition of bumper. Does it protect ramp
properly?
2.___ Remove dirt and trash from pit and determine if pit drain is open.
3.___ Inspect motor, controls, starter, push buttons, solenoids, etc. Clean,
adjust and lubricate as necessary. Be sure disconnect switch can be
locked.
4. Hydraulic Units.
a.___ Inspect coupling, pump, control valves, piping, relief valve reservoir,
fill pipe, cap, vents, etc. Clean, adjust, and lubricate as needed.
b.___ Inspect cylinder, ram, packing glands, etc. Add or renew packing as
required.
c.___ Change oil as required. Review the Material Data Safety Sheets (MSDS)
for disposal of used oil. If appropriate, recycle oil at an authorized
station.
5. For Electro-Mechanical Units.
a.___ Clean and inspect coupling, reduction gear, sprockets and chain, gear
trains, screw and lever, and/or other mechanical features. Look for
misalignment, loose bolts, evidence of binding or wear, excessive
clearance, etc., tighten as necessary.
b.___ Examine lubrication devices. Service if required.
c.___ Test operation of ramp in all directions using a load if possible.
Note if ramp holds and does not creep when load is applied or removed.
Adjust if necessary.
d.___ Check manual operation, power disengagement, etc.
e.___ Lubricate as required.
f.___ Clean up work area.
Tools & Materials:
1. Standard Tool Kit
Plus Pipe wrenches to 24"
Tubing cutters
Flaring tool
Small acetylene outfit
Packing tool kit and packing
3/4" socket set
Crescent wrenches to 14"
2. Hydraulic fluid
3. Lubricants. Consult the MSDS for hazardous ingredients and proper personal
protective equipment (PPE).
4. Cleaning materials. Consult the MSDS for hazardous ingredients and proper
PPE.
Table of Contents | Next