Man Hours .75
Special Instructions:
1. Use rubber gloves, apron, and plastic face shield.
2. Do not spark battery terminals or smoke while performing maintenance.
3. Review manufacturer's instructions.
Items to Check & Initial Completion:
1.___ Inspect for structural defects and deposits.
2.___ Clean off corrosion deposits and apply silicone grease to terminals.
3.___ Inspect water level and take specific gravity readings. If reading is less
than specified by battery manufacturer, the battery should be replaced with
a freshly charged one. The old battery should be charged and tested before
discarding.
4.___ Add distilled water to raise electrolyte to proper level.
5.___ Push test buttons and observe light operation. (See manufacturers
instructions.)
6.___ Check vent holes.
7.___ Clean exterior with dry cloth, Paint if necessary with an
appropriate type and color paint.
8.___ Unplug unit to check operation.
9.___ Clean up from work area.
Tools & Materials:
1. Standard Tool Kit
Plus Insulated pliers and screwdrivers
Wire strippers
Wire crimpers
Voltmeter - Ohmmeter - Milliammeter
Clamp on meter(volt - ohm - amp meter)
Soldering kit
1/8" 25' fish tape
Burnishing tool
2. Distilled water
3. Cleaning equipment and materials
4. Hydrometer
5. Silicone grease
6. Acid resistant rubber apron, gloves, and face shield.
Table of Contents | Next