Application: Man Hours 1
This applies to entrance doors used in main entries to building where a poorly
operating door may be dangerous and cause congestion.
Special Instructions:
Set suitable barriers at the entrance and exit of the door. Prevent obstructions
from impeding pedestrian traffic around the work area.
Items to Check & Initial Completion:
Hinged Doors
1.___ Inspect the frame and supporting structures.
2.___ Inspect hardware; hinges, latch keeper, lock. etc. Apply graphite where
needed, wipe off excess.
3.___ Inspect glass, putty, or retaining pieces. Correct any deficiencies.
4.___ Operate door to observe functioning of check. Adjust and service as
needed.
5.___ Touch up paint as needed.
6.___ Clean up and remove all debris from work area.
Revolving Doors
1.___ Remove obstructions and clean out track.
2.___ Fold door. Note action and freedom of motion.
3.___ Inspect locking device, adjust as needed.
4.___ Clean pivot points and apply graphite.
5.___ Inspect felt or rubber seals.
6.___ Set the emergency fold pressure on the door to the manufacturer's
specifications. Check automatic speed control, which should limit speed of
door to 12 RPM.
7.___ Touch up paint as required.
8.___ Clean up all debris from work area.
Tools & Materials:
1. Standard Tool kit.
2. Graphite. Consult the Material Safety Data Sheets (MSDS) for hazardous
ingredients and proper personal protective equipment (PPE).
3. Clean wiping cloths
4. Suitable barriers
Application: Man Hours 1
This applies to entrance doors used in main entries to building where a poorly
operating door may be dangerous and cause congestion.
Special Instructions:
Set suitable barriers at the entrance and exit of the door. Prevent obstructions
from impeding pedestrian traffic around the work area.
Items to Check & Initial Completion:
Hinged Doors
1.___ Inspect the frame and supporting structures.
2.___ Inspect hardware; hinges, latch keeper, lock. etc. Apply graphite where
needed, wipe off excess.
3.___ Inspect glass, putty, or retaining pieces. Correct any deficiencies.
4.___ Operate door to observe functioning of check. Adjust and service as
needed.
5.___ Touch up paint as needed.
6.___ Clean up and remove all debris from work area.
Revolving Doors
1.___ Remove obstructions and clean out track.
2.___ Fold door. Note action and freedom of motion.
3.___ Inspect locking device, adjust as needed.
4.___ Clean pivot points and apply graphite.
5.___ Inspect felt or rubber seals.
6.___ Set the emergency fold pressure on the door to the manufacturer's
specifications. Check automatic speed control, which should limit speed of
door to 12 RPM.
7.___ Touch up paint as required.
8.___ Clean up all debris from work area.
Tools & Materials:
1. Standard Tool kit.
2. Graphite. Consult the Material Safety Data Sheets (MSDS) for hazardous
ingredients and proper personal protective equipment (PPE).
3. Clean wiping cloths
4. Suitable barriers
Table of Contents | Next