Work Order Meter Readings

This help file applies to an out-of-date version of MainBoss.
The most recent version of MainBoss is MainBoss 4.2.4.
For the latest version of this help file can be found here.

< Previous section  |  Table of Contents  |  Index  |  Next section >

You can record a meter reading from a work order. Start in the work order's Meters section, click on a meter, and click New Work Order Meter Reading. The resulting window contains the following:

Meter Class: A read-only field giving the class of the meter whose reading you are recording. For more, see Meter Classes.

Unit: A read-only field giving the unit with which the meter is associated. For more on units, see Units.

Work Order: A read-only field giving the work order with which this meter reading is associated. For more on work orders, see Work Orders.

UOM: A read-only field giving the units of measure associated with this meter. For more on units of measure, see Units of Measure.

Reading Offset: A read-only field giving the offset associated with this meter. For more, see the section titled Effective vs. Actual Readings in Meters.

Effective Date: The date/time when the reading was taken.

Reading: The actual reading from the meter. When you type a number in this field, MainBoss automatically sets "Effective Reading" to "Reading" plus "Reading Offset".

Effective Reading: The sum of "Reading" and "Reading Offset". This gives you the true value of the meter, after adjusting for roll-over, resetting, and other special conditions.

Save & Close: Saves the current record and closes the editor window.

Cancel: Closes the window without saving any changes you've made to the record since the last time you saved. When you Save the record, the Cancel button changes to Close, indicating that you can safely close the window without losing any changes.

Close: Closes the window. This button only appears after you've saved changes with Save or before you've entered any data at all. Otherwise, the button is labeled Cancel.

For more on meter readings, see Meter Readings. For more on editors in general, see Using Editors.

< Previous section  |  Table of Contents  |  Index  |  Next section >